As happens when the floor is covered by ceramics and one of them is broken, the carpet can also be repaired when a small part of its surface is damaged. To do so, we just have to follow the following steps:

The carpet is a material widely used in the house for many years, in fact, it is estimated that it has begun to be used in Mongolia or Turkestan, between the 4th and 2nd centuries BC. C, although in Spain it has arrived a little later, in the 10th century, carried by the Arabs.

The carpets are made on a loom wool, yarn or fiber, which, in many cases, used to cover the floors of our rooms and as we said, are a great weapon in the decor and comfort of our rooms tissue.

As with all materials used to cover the floor, the carpet can be damaged. The problem is when the damage occurs only on a small part of the surface. However, there is a way to solve this problem, so that it is not necessary to change the entire carpet when a piece of it is damaged.

As happens when the floor is covered by ceramics and one of them is broken, the carpet can also be repaired when a small part of its surface is damaged. To do so, we just have to follow the following steps:

Actually what we will do is patch the carpet , for this we must get a piece of the carpet , surely we will have some remains that have been left over at the time of installation. If this is not the case, we will have to resort to using a piece of carpet that is located under a piece of furniture that is immovable.

Then, we will get a paint can lid that is totally clean and we will place it on the damaged area. With the help of a hammer and two small nails for concrete, we will fasten the cover to the floor. We must ensure that the nails are not too attached to the floor, so that it is easier to remove them later.

The paint can lid will serve as a guide to cut the surface in a circular shape. We will do it with a well sharpened cardboard box.

  • It is done in the shape of a circle because it is less obvious than in the shape of a square, for example.

The next step will be to remove the nails and the cover, which we will place on the piece of carpet that we had planned to make the patch, and we will do the same work so that we have the same shape that we are going to cover.

  • We only have to pay attention that if the carpet has any drawing, it must coincide with the cut part.

Then we will have to vacuum the surface of the carpet where we have left the space to cover, to later place double-sided adhesive tape. The next step is to place the new patch, matching the drawing, in case the carpet has one.

Finally we will only have to put pressure on the patch just glued, for which we can use any heavy element located on a board.

If this didn’t work then you can hire Carpet repair specialists for your carpet.